Jenn-Air JDS9860AAW Installation Manual page 2

_k WHEN REPLACING AN EXISTING UNIT, A MAXIMUM CUT DEPTH OF
23 1/2" (59.7 cm) IS ACCEPTABLE.
_< "F"
CUT DEPTH
[_ OTE:
ON COUNTER TOPS WITH
FORMED FRONT EDGE,
SHAVE RAISED SECTION
TO CLEAR TOP.
BEFORE ATTEMPTING
INSTALLATION, ADJUST
RANGE LEVELING LEGS
rO ACCOMMODATE
THIS DIMENSION.
"D'COUNIER
TOP HEIGHT
CAUTION:
SEE
NOTE #I
"C" CABINET
OPENING
_
///_FIGURE 1
SOME WHI-E EUROPEAN STYLE CABINETS ARE EQUIPPED
WITH DELICATE WHITE VINYL DRAWER AND DOOR FRONTS.
THE VINYL MAY NOT BE DESIGNED TO WITHSfAND THE HEAT
=RODUCED BY THE NORMAL SAFE OPERAIION OF A SELF-CLEANING
RANGE. D_SCOLORATION OR DELAMINATION MAY OCCUR. TO
AVOID POSSIBLE DAMAGE, WE RECOMMEND INCREASING THE 50"
(76.2 cm) CABINET OPENING TO 51 1/4" (79.4 cm) MINIMUM
AND USING A HEAT SHIELD KiT (CABKIT V), WlIICH MAY BE
ORDERED SEPERATELY. THE COUNTERTOP CUr-OUT MUST
REMAIN
30" (78,2 cm).
FLAT
AREA
"A" NORMAL
COUNTER
TOP DEPTH
COUNTER TOP SEE
lIEIGIIT "_ NOTE #I
..
# C
CAB I N E T'_"'--_
-- OPENING /
FIGURE 2
COUNTER
TOP
DEPTH
NOTES:
1. Provide for either a 3-wire or 4-wire 120/208, 120/240 volt outlet per applicable cord in shaded area shown. Refer
to installation instructions for proper positioning of outlet. This is also the recommended gas line location.
2. Dimension K (figure 3, page3) is from the wall to the side edge of the oven door. It does not includethe curvature
of the glass or the depth of the handle.
3. Dimension L (figure 3, page 3) is with the leveler legs adjustedall the way in. This may vary slightly upon leveling
leg adjustment.
4. Do not use grout, epoxy, etc., to install this unit. Installation must allow for removal of this appliance from the
installed location for purposes of servicing.
-2-