Jenn-Air JB36NXFXLW Installation Manual page 18

Side View
A
A. Top grille filler D. Grille panel
B. Soffit E. Door panel
C. Airflow
Panel Kit Models
Excessive Weight Hazard
Use two or more people to move and install panels.
Failure to do so can result in back or other injury.
1=
2=
Align top grille filler (provided in the door kit) with the bottom
edge of the soffit. Use as a template, and mark where to drill
the holes.
Using slotted hex head screws (provided), attach the top grille
filler to the soffit.
Side View
A. Top grille filler
B. Hex head screw (provided)
Drilling Templates (custom wood panels only)
IMPORTANT: The template can be used for either a 3/8"(0.95 cm)
or a 1/8"(0.32 cm) reveal installation.
• The drilling templates are double-sided.
• On the template, locate the diagram of your refrigerator. Then,
follow the letters and colored arrows to correctly place the
drilling template on the panels.
• The drilling holes are precut into the template.
Prepare Custom Overlay Panels
IM PORTANT:
• The process for installing overlay panels on the refrigerator is
the same for both custom panels and panel kits.
• The drilling templates are used only for custom wood overlay
panels.
The panels included in the panel kits are predrilled for the
mounting brackets only. See "Complete Installation" later in
this section, for instructions on drilling additional holes in the
door panels.
NOTE: For 36" model door panels which are right-hand swing
and left-hand swing specific use the following instructions:
• Hinge on right-hand side - Use the holes, located on the
back side of the door panel, that are circled in red.
• Hinge on left-hand side - Use the holes, located on the
back side of the door panel, that are circled in blue.
• The film covering on stainless steel door panels must be
removed before installing brackets.
1. Place panels on a firm, flat surface with the front facing down.
2. Using the templates (provided), predrill %" pilot holes into the
wood rails bordering the door(s), drawer and top grille panels.
Follow the instructions printed on the template.
3. Using the installation block as a guide for depth, screw the
door studs (provided) into the predrilled door panel (two door
studs per door).
4=
A. Door stud
B. Installation block
Insert the hex head pointed screws (provided) into the wood at
the top of the door panels where they were predrilled.
NOTE: It is critical to use the %" screw, the longest length
provided, to attach the bracket to the top of the door panel.
These hex head pointed screws are used only to attach this
mounting bracket.
18
A. Soffit C. Grille panel
B. Airflow D. Door panel