Install Overlay Series Custom Panels - Jenn-Air JB36SSFXLA Installation Manual

After moving the refrigerator to its final location:
1. Use a " socket driver to turn the leveling bolts clockwise to
extend the legs to the floor as shown. The rollers should be off
the floor.
A B
A. Rear leveling bolt
B. Front leveling bolt
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
2" (5 cm)
D
A. Center board " (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the
door alignment or top grille fit. To avoid damage to the cabinet
or leveling legs, do not apply more than 50 inch-pounds
(5.65 Nm) of torque to the leveling bolts. The leveling legs can
be extended to a maximum of 1 " (3.18 cm) below the rollers.
4. For Overlay models, additional adjustments may be needed
after the custom panels are installed.
" (6.35 mm) of
A B
C
" (6 mm)
max.

Install Overlay Series Custom Panels

IMPORTANT:
Install the custom handles prior to installing the panels on the
refrigerator. For more information on Jenn-Air custom handle
selection, refer to the Jenn-Air Catalog, visit
www.jennair.com, or call 1-800-JENNAIR (1-800-536-6247).
In Canada, visit www.jennair.ca, or call 1-800-807-6777.
Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels" section.
A
Jenn-Air is not responsible for the removal or addition of
B
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator door(s)
and freezer drawer.
2. Open the refrigerator door(s) and freezer drawer and remove
the trims and corner caps on each door as shown.
A
B
C
A
A. Corner caps
B. Refrigerator door trims
C. Freezer drawer trim
A
B
A
23