Conductivity Probe; Conductivity Probe Connection; Conductivity Probe Programming; Conductivity Temperature Programming - Hach 900 MAX Instrument Manual

Section 5

5.5 Conductivity Probe

5.5.1 Conductivity Probe Connection

Pin
A
B
C
D

5.5.2 Conductivity Probe Programming

5.5.3 Conductivity Temperature Programming

Page 76
Conductivity Probe
Table 11 Conductivity Probe Wiring (J20)
Signal Description
Probe
Probe
RTD
RTD
1. From the Main Menu, select
2. Highlight Select Inputs using the
3. Highlight Conductivity (COND.) using the
4. Press
CHANGE CHOICE
press .
ACCEPT
5. Enter a logging interval using the numeric keypad, then press
Valid logging intervals are shown on the status bar along the bottom edge
of the display.
6. Press
CHANGE CHOICE
to continue.
ACCEPT
7. Select another channel to configure or press
step. Press
MAIN MENU
1. From the Main Menu, select
2. Highlight Select Inputs using the
3. Highlight Conductivity Temperature (COND. TEMP.) using the
keys, then press
DOWN
4. Press
CHANGE CHOICE
press .
ACCEPT
5. Enter a logging interval using the numeric keypad, then press
Valid logging intervals are shown on the status bar along the bottom edge
of the display.
6. Press
CHANGE CHOICE
Press .
ACCEPT
Wire Color
OPTIONS>ADVANCED OPTIONS>DATALOG.
and keys. Press
UP DOWN
and
UP DOWN
to cycle between Logged and Not Logged, then
to select the appropriate units (ms, µs). Press
RETURN
to return to the Main Menu display.
OPTIONS>ADVANCED OPTIONS>DATALOG.
and keys and press
UP DOWN
.
SELECT
to cycle between Logged and Not Logged, then
to select temperature units (°C, °F).
Black
Red
White
Green
.
SELECT
. Press .
SELECT
.
ACCEPT
to back up one
.
SELECT
and
UP
.
ACCEPT
8990options.fm