Chapter 8: Simple Network Management Protocol; General Snmp Settings - Cisco Small Business WAP551 Administration Manual
Wireless-n access point with poe/ wireless-n selectable-band access point with poe
Hide thumbs
Also See for Small Business WAP551:
- Administration manual (225 pages) ,
- Quick start manual (13 pages) ,
- Quick start quide (13 pages)
Table of Contents
Advertisement
Simple Network Management Protocol
General SNMP Settings
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
This chapter describes how to configure the Simple Network Management
Protocol (SNMP) to perform configuration and statistics gathering tasks.
It contains these topics:
•
General SNMP Settings
•
Views
•
Groups
•
Users
•
Targets
You can use the General page to enable SNMP and configure basic protocol
settings.
To configure general SNMP settings:
Select SNMP > General in the navigation pane.
Select Enabled for the SNMP setting. SNMP is disabled by default.
Specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to requests from port 161. However, you
can configure this so that the agent listens to requests on a different port. The valid
range is from 1025 to 65535.
Configure the SNMPv2 settings:
•
Read-only Community—A read-only community name for SNMPv2
access. The valid range is 1 to 256 alphanumeric and special characters.
8
129
Advertisement
Table of Contents
