Network Interfaces - Cisco Small Business WAP551 Administration Manual

Status and Statistics

Network Interfaces

Network Interfaces
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
- Active—A connection session is established and packets are being
transmitted and received.
- Established—A connection session is established between the WAP
device and a server or client, depending on the role of each device with
respect to this protocol.
- Time Wait—The closing sequence has been initiated and the WAP is
waiting for a system-defined timeout period (typically 60 seconds)
before closing the connection.
You can click Refresh to refresh the screen and show the most current information.
Use the Network Interfaces page to show configuration and status information
about the wired and wireless interfaces. To show the Network Interfaces page,
select Status and Statistics > Network Interface in the navigation pane.
The Network Interfaces page shows this information:
• LAN Status—These settings apply to the internal interface.
To change any of these settings, click the Edit link. After you click Edit, you
are redirected to the VLAN and IPv4 Address Settings page. See
IPv4 Address Settings
• Radio Status—These settings include the Wireless Radio mode (Enabled
or Disabled), the MAC address associated with the radio interface (or both
radio interfaces for WAP561 devices), the 802. 1 1 mode (a/b/g/n), and the
channel used by the interface.
To change the wireless settings, click the Edit link. After you click Edit, you
are redirected to the Radio page. See
• Interface Status—This table lists status information for each Virtual Access
Point (VAP) and on each Wireless Distribution System (WDS) interface. On
WAP561 devices, WLAN0 or WLAN1 precedes the VAP interface ID to
indicate the associated radio interface. WLAN0 represents radio 1 and
WLAN1 represents radio 2.
for descriptions of these fields.
Radio for descriptions of these fields.
2
VLAN and
14