Install Sensor &Alarm - Swann 8600 Series User Manual

Item
3 AUDIO IN
4 S-VIDEO
5 PS/2 port
5 AUDIO OUT
6 USB MOUSE port
7 RJ45 port
8 VGA port
9 ALARM IN
10 ALARM OUT
11 POWER INPUT
12 COM port
13 AUDIO OUT
14 VIDEO IN
Notice: The resolution of VGA output is 800*600/60Hz. If connected through VGA port, please assure your display supports the display
mode.(For most of LCD screens, they can adapt to it automatically without adjustment manually)
2.3.2 Install Sensor &Alarm
The DVR has 16 channel alarm input and 4-channel alarm output.
Alarm Input:
The alarm input is triggered by electric level (High: 5V, Low: 0V). Users can connect external sensors, like gas detector,
smoke detector and infrared detector. Once the DVR detects that the electric level meets the setting users make, it will
trigger DVR to record or alarm out.
For example, a sensor is connected to alarm input1. If the sensor gives relay out(switch on/off), user need set the sensor
according to the switch status at alarm. If the switch is open at alarm, users need set SENSOR TYPE as NC(Normal
Close),. Cable A and B will be disconnected once the sensor detect event. It will detect +5V (high level) to sensor1 when
events happen. DVR is triggered. it will record and output alarm.
10
Digital Video Recorder User Manual
Name
8-channel Video input
S-Video output, connect to monitor
Connect to PS/2 mouse
Audio output, connect to the sound box
Only for USB mouse
Connected to internet
VGA output, connect to monitor
Connect to external sensor 1-8. Please refer to 2.3.2 Install Sensor &Alarm
Relay output 1-4. Connect to external alarm. Please refer to 2.3.2 Install Sensor &Alarm
DC 12V
For debug
Audio output, connect to the sound box
Connect camera
Tab 2.3 Definition of Rear Interface
Description