Remote Preview - Swann 8600 Series User Manual

1. connect the DVR to internet through a router or virtual server.
Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and router.
STEP1
Enter Video to set network video parameters like resolution, frame rate etc.
STEP2
Forward IP address and port number in Virtual Server setup of the router or virtual server. Close firewall.
STEP3
Notice: Forwarding block may be different in different routers and server, please check your router manual.
If users want to utilize dynamic domain name, need apply for a domain name in a DNS server supported by the
STEP4
DVR or router. Then add to the DVR or router.
Now this unit only supports
About the router, please check in the router manual.
Open IE browser, input IP address, or dynamic domain name and enter. If HTTP port is not 80, add the port
STEP5
number after IP address or domain name.
IE will download activeX automatically. Then a window pops up and asks for user name and password.
STEP6
Input name and password correctly, and enter to view.
STEP7
Notice: If you cannot download and install activeX, please refer to
2. Connect the DVR to internet directly.
Input IP address, Subnet, Gateway gotten from your ISP. If using ADSL, please input user name and password,
STEP1
and click OK. The DVR will connect the server and show "connection succeeds".
The following steps are the same as STEP4-7 of the connection way above.
STEP2

6.2 Remote Preview

It will first enter remote preview interface as below.
Digital Video Recorder User Manual
www.dns2p.com or www.88IP.net.
Appendix A FAQ Q7.
77