Print Head Print Line Position - Argox Xellent X-1000VL User Manual

Print Head Print Line Position

When the label only exhibits locally inferior printing quality and the
ribbon is not wrinkled, the position of the print head shall be
adjusted, and the adjusting position is shown as Fig. 1. The viewing
direction is facing the machine, and using hex socket screw driver
for the adjustment.
The adjusting portions for two hex socket screw locks marked in Fig.
1 are shown in Fig. 2 and Fig. 3. When the right side of the label
exhibits inferior printing quality, as shown in Fig. 2, the screw at the
right side shall be adjusted. When the left side of the label exhibits
inferior printing quality, as shown in Fig. 3, the screw at the left side
shall be adjusted. The adjusting steps are as follows:
1. Clockwise rotate the screw a half circle and test printing;
observe whether the printing quality has been gradually
improved or not; and stop the adjustment if the quality is
improved.
2. Repeat Step 1; if the printing quality has not been gradually
improved after five times, counterclockwise rotate five
circles back to the original position and then proceed Step
3.
3. Counter-clockwise rotate the screw a half circle and test
printing; observe whether the printing quality has been
gradually improved or not; and stop the adjustment if the
quality is improved.
78