How To Remove Scale From The Ice Making System; June - Scotsman SCCG50 Enodis Installation And User Manual

How to remove scale from the ice making system.

1. Scoop out all of the ice, either discard it or save
it in an ice chest or cooler.
2. Press and HOLD the On/Off button in for 3
seconds until the Green light goes out.
3. Press and HOLD the both the Clean-Reset and
On/Off buttons for 5 seconds. The Time to Clean
light will blink on and off.
4. Pour 4 ounces of Scotsman Ice Machine Scale
Remover (available from a local Scotsman
Distributor or Dealer) into the ice machine
reservoir.
5. Operate the machine for about ½ hour.
6. Push and release the On/Off switch. The
machine will begin to flush out the cleaning
solution.
7. Operate the machine for another ½ hour.
8. Push and release the On/Off switch. The
machine will stop the cleaning process.
9. Pour a gallon of hot (95
the bin to flush out the drain.
Pour Scale
Remover Here
o o
F. – 115 F.) water into

June 2008

Page 14
Installation and User's Manual
10. Clean the bin liner of mineral scale by mixing
some ice machine scale remover and hot water,
and using that solution to scrub the scale off of the
liner.
11. Rinse the liner with hot water.
12. Sanitize the bin interior.
13. Replace the ice removed in step 1.
14. Push and release the On/Off button to restart
ice making.
The ice scoop should be washed regularly, wash it
just like any other food container.
What to do before calling for service
Ice cubes are incompletely formed
•
Clean the ice making system
Low capacity
•
Check for restricted drain or standing water
in the bin
•
Clean the air cooled condenser fins
No ice
•
Check on-off switch
•
Check electrical breaker
•
If the Check Water light is flashing Red,
check water supply. The control system
checks for water every 20 minutes. When the
water supply is restored, the machine will
automatically restart ice making.
Time to Clean light is on
•
Clean the ice making system.
SCCG50 & SCCP50