Removing Scale From Ice Making System.; How To Remove Scale From The Ice Making System - Scotsman SCN60 Installation And Use Manual

SCN60
Installation and Use

How to remove scale from the ice making system.

Cleaning this machine involves adding a solution of
scale remover and water to the ice machine and
continuing to add it as it makes ice. The scale
remover must be diluted to the correct ratio. A
squirt bottle will make adding the scale remover
much easier when the unit is built in. If not built in,
remove the top panel for reservoir access.
Recommended tools: Rubber gloves, squirt bottle
& scale remover. Pre-Mixed 16 oz squirt bottle of
scale remover is part number 19-0664-01.
1. Scoop out and discard all of the ice.
2. Press and release the On/Off button.
Ice
Making
3. Open door and locate screws at upper back wall
of bin. Remove the two screws.
Ice
Making
Screws
4. Remove the back wall of the bin by lowering it
down past the scoop holder, feel free to rotate the
scoop holder loop down to make more room.
Clean
Check Time to
Reset
Water Clean
Clean
Check Time to
Reset
Water Clean
May 2011
5. Push tab on front edge of reservoir cover and
remove the cover. Note: Adjacent wires are low
voltage and are not hazardous.
Push In Tab to Release Cover
Lift Reservoir Cover to Remove
Page 14
Float Valve
On/Off Lever
Reservoir Cover
Release Tab