Door Covering - Scotsman SCCG50 Enodis Installation And User Manual

Door Covering

Door Panel
The ice machine is supplied without a conventional
door covering so it can be decorated to the user's
preference. Scotsman offers several coverings
including white, black and stainless steel. In
addition, a custom built panel can be placed onto
the door.
Door Panel Attachment
To attach a Scotsman supplied panel:
Note: If door swing is to be changed, it must be
done before panel is attached.
The panel will be held on by 6 sheet metal screws
and 2 machine screws.
1. Remove the gasket and retain for later use.
2. If the door panel is stainless steel, remove any
plastic covering the stainless steel panel.
3. Place the panel onto the outside of the door,
and secure it to the door using two machine
screws, located at the left center and right
center.
4. Fasten the panel to the door using the 6 sheet
metal screws. In the hinge area, use the
outermost screw holes.
5. Place the covers over the hinge
areas, and secure each cover to
the door using a sheet metal
screw.
6. Insert hole plug over screw
installed in step 5.
7. Return the gasket to its original
position.
Installation and User's Manual
Custom Panel
A custom panel of wood or other material not
exceeding 15 lb can be attached to the door.
Attachment is from the ice side of the door. Holes
are provided in the door for this purpose.
See instructions in information packet to create and
attach a custom panel:
Hole Plug
June 2008
Page 6
SCCG50 & SCCP50
Cover
Gasket