Oki Microline 8480 FB User Manual page 43

at the top such as a large dark area on one side or a cutout. Such
types of forms defeat the skew sensor.
Auto Align (POW)
Note This setting interacts with the other "Align" items in the
Group Manual Feed group (see page 38).
Sets the alignment method (skew adjustment) engaged for
manual feed from the platform when the printer is turned on.
Note This setting does not affect the printer when it initializes
in response to an I-Prime signal.
Available settings: Align 1, Align 2, Align 3, Align 4, or
SelectAutoAlign [the default].
• Select Auto Align [the default]: Skew adjustment is set by
Auto Align in the Manual Feed group. (see page 42).
• Align x (x = 1, 2, 3, or4): Skew adjustment is set by the
corresponding Alignx Pos.Adj in the Manual Feed group (see
page 42).
Auto CR
IBM emulation only.
The default is No. If you want the printer to automatically add a
carriage return when a Line Feed is received at the end of a line,
change the setting to Yes.
Auto Eject Pos.
This sets when the paper ejects, based on the distance between
the vertical center of the characters on the last line of the page
and the bottom of the page. Choose 3.18 mm (1/8") or 6.35 mm
(1/4") [the default].
Auto Feed XT
The default is Invalid. Change it to Valid if your system uses pin 14
of the parallel interface to control automatic line feed.
Explanation of Function Setting Menu Items • 43
Microline 8480FB User's Guide