Connecting The Power Cord - JVC VN-C655 Instructions Manual

3 Connecting the Power Cord

Connect the camera to DC 18 V.
For a system with multiple VN-C655s
In a system where more than one VN-C655 are used, turn on the power for a VN-C655 first and
proceed the setting to 2-4 Other Settings with V.Networks Setup Tool. Only then turn on the power for
a second one and go on to 2-4. Repeat the procedure for the other cameras.
Note
The IP address of VN-C655 is set to "198.168.0.2" at the factory. Proper access cannot be
established due to IP address redundancy if the power is turned on for multiple cameras at
one time under a single LAN environment. Do not turn on the power for multiple cameras
at the same time. If an IP address redundancy occurred, ensure that only one VN-C655 exists
on a single LAN environment and wait for some time (at least 10 minutes). Or turn off the
power once for all network equipment and turn it on again for proper access to VN-C655.
Connect the supplied AC adaptor to the DC 18 V
input terminal on the terminal stand.
15