Settings (Step 2 Setting the Network)
2-4 Other Settings with V.Networks Setup Tool [2. Alarm Setting]
This section describes alarm setting.
Alarm input is activated in the following cases.
• Input signals are received from an input terminal located on the rear panel of the camera, [ALARM
INPUT 1] or [ALARM INPUT 2]. (
Operation when alarm input is activated.
• Output signals are sent from the output terminal located on the rear panel of the camera, [ALARM
☞
OUTPUT]. (
Page 19)
• Alarm information is reported to [V.Networks Controller.] (
• Alarm Images are recorded. (
1.
Start up [V.Networks Setup Tool] and select [Alarm].
2.
When the setting is complete, select [Apply] and then
32
☞
Page 18)
☞
Page 34)
☞
Page 33)
1
2
3
4
.