Table of Contents
Advertisement
Observe all safety precautions when operating the tool. Read Section 2, Safety,
and Section 3, Hydraulic System Requirements, before operating the tool for
the first time.
1. If the conductor is insulated, remove the insulation from the end of the
conductor.
• Use an insulation stripping tool. If a stripping tool is not available,
carefully shave the insulation from the cable.
• Be sure not to nick or cut the strands of the conductor.
2. Remove any oxide or foreign matter from the exposed conductor. A
bright, shiny surface is required for a good connection. Do not wire-
brush tin-plated copper conductors or tinned connectors.
3. Install the connector sleeve onto the conductor.
1. Clean the nibs on the tool. Remove all traces of lubrication from each
tool nib before crimping.
2. Pull the ringed latch pin out of the latch. Rotate the latch away from
the crimping head and then place the crimping head over the connector
sleeve on the conductor. Close the latch and reinstall the ringed latch
pin.
3. Move the hydraulic system control valve to the
!
position.
ON
Advertisement
Table of Contents
