Stanley CT06 Safety And Operation Manual page 17

The CT06 Hydraulic Crimping Tool has two main components in the Anderson
compression head:
• The cam yoke assembly forms the base of the compression head. It
functions as a movable piston die to provide the crimping force.
• The latch assembly bridges the cam yoke across the end of the head.
The latch nib in the center of the assembly is the stationary die.
The following procedure describes how to remove and replace the latch nib.
1. If the hydraulic hoses are connected:
• Turn the hydraulic system control valve OFF.
• Disconnect the hydraulic hoses—first the hydraulic input (supply)
hose, then the output (return) hose.
2. Clean the surfaces of the compression head to remove any dirt or
grease.
3. Pull the pin out to release the latch (Figure 4–2).
4. Rotate the latch away from the head to provide access to the nib/nest
die.
5. To release the nib/nest die, drive the roll pin out of the center of the
latch.
6. Remove the nib/nest die by rotating it out and around the small pivot
pin inside the latch.
7. Insert the new nib/nest die, rotating it around the pivot pin as in step 6.
Make sure the nib/nest die is oriented so the notched side faces the
pivot pin.
8. Press the nib/nest die firmly until it locks into place.
9. Drive the roll pin into the center of the latch to retain the nib/nest die.
10. Close the latch. Insert the latch pin.
!