Adjusting Volume Between Input Sources <Volume Trim - Yamaha HTR-2064 Owner's Manual

■
Adjusting volume between input sources
Volume Trim
Input source: All
Reduces any change in volume when switching between input
sources by correcting volume differences in each input source. You
can adjust this parameter for each input source.
Adjustable range -6.0 dB to 0.0 dB to +6.0 dB
Default setting 0.0 dB
Adjustment 0.5 dB steps
increments
■
Combining HDMI input source video and
audio
Audio In
Input source: HDMI 1-3
Combines video from HDMI input sources with analog/digital
audio inputs in situations such as:
– an external device is connected with an HDMI cable but cannot
transmit audio through HDMI
Inputs that change the audio source
HDMI1
Audio;;;AUDIO1
Assignable audio input jacks
To change assignments, select an input source (HDMI 1-3) as the
video input first, and then select audio input jacks in this menu.
J
1 : AUDIO 5-6 are also available when the "Audio Return Channel" function is on,
and the source is used for the TV audio input (TVAudio).
Set as follows according on the desired combination of audio input
jacks.
Audio inputs Settings method
Optical digital audio Select AUDIO 1 or AUDIO 4. Connect the external
input component audio cable to the optical jack for the
selected input.
Coaxial digital audio Select AUDIO 2 or AUDIO 3. Connect the external
input component audio cable to the coaxial jack for the
selected input.
Analog audio input Select AUDIO 5 or AUDIO 6. Connect the external
component audio cable to the audio jack for the
selected input.
• For details of settings, refer to "Receiving audio from other input
sources" (☞p. 15).
• To return audio inputs to their previous settings, display this item
again, and select the original input jack.
■
Displaying information on audio/video
signals
Signal Info
Input source: HDMI 1-3, AUDIO 1-4
Displays information on digital audio and video signals on the
VOL.
front panel display. You can display the signal information by
SW
C
L R
iENTER
pressing on the menu item and using
SL SR
Menu item
FORMAT
Configuring the settings specific for each input source (Option menu)
Audio information
FORMAT
CHAN
SAMPL
B RATE
Video information
V IN
V OUT
V.MSG
(appears only
when an error
has occurred)
• "No Signal" is displayed when no signals are being received, and
J1
• The bit rate may vary during playback.
iCursor B / C.
VOL.
SW
Dolby D
C
L R
SL SR
Information
SETUP
Format of audio signals.
The number of input signal channels (front/surround/
LFE).
For example, if input signal channels are 3 front
channels, 2 surrounds and LFE, "3/2/0.1" is
displayed.
The sampling frequency of analog-to-digital
conversion.
The bit rate of input signal per second.
Format and resolution of video input signal.
Format and resolution of video output signal.
Error messages about HDMI signals and components.
Error message
HDCP Error HDCP authentication failed.
Device Over The number of connected HDMI
components is over the limit.
"---" is displayed if this unit cannot recognize the incoming
signal.
31
En