Fisher & Paykel OB60 Series User Manual page 24

Care and cleaning
22
Removing and refitting the side racks and catalytic panels
Important!
Only some full ovens have catalytic panels and a lamp in the left oven wall.
Fixing screw
Fig.20a Side rack and catalytic panel in full oven cavity
To remove a side rack and catalytic panel
1 For easier access to the fixing screws, we recommend removing the oven door first. See
'Removing and refitting the oven door. '
2 Using a small coin or a flat-head screwdriver, loosen and remove the front and back fixing screws,
as shown.
3 Remove the side rack.
Once you have removed a side rack, the catalytic panel behind it (if fitted) will also be released.
Important!
In some full ovens, the back of the oven is also a catalytic panel, but this is not reversible and should not be
removed.
To refit a side rack and catalytic panel
1 If the oven has catalytic panels, align a panel with the fixing screw holes and hold it in place,
making sure that:
the arrow on the panel is pointing up
if one panel has a hole, it will be on the left oven wall (to fit around the lamp)
2 Loosely screw in the the back fixing screw.
3 Position the side rack. In full ovens, make sure it is the right way up, as shown.
4 Loosely screw in the front fixing screw.
5 Check that both fixing screws are straight, then tighten them.
6 If you removed the door, refit it.
Fixing screw hole
Fig.20b Side rack in compact oven cavity