Configuring Port Forwarding To Local Servers - NETGEAR WNR612v2 User Manual

Wireless-N 150 Router WNR612v2 User Manual
Port triggering does not need to know the computer's IP address in advance. The IP
•
address is captured automatically.
Port forwarding requires that you specify the computer's IP address during configuration,
•
and the IP address must never change.
Port triggering requires specific outbound traffic to open the inbound ports, and the
•
triggered ports are closed after a period of no activity.
Port forwarding is always active and does not need to be triggered.
•

Configuring Port Forwarding to Local Servers

Using the port forwarding feature, you can allow certain types of incoming traffic to reach
servers on your local network. For example, you might make a local Web server, FTP server,
or game server visible and available to the Internet.
Use the Port Forwarding screen to configure the router to forward specific incoming protocols
to computers on your local network. In addition to servers for specific applications, you can
also specify a default DMZ server to which all other incoming protocols are forwarded. The
DMZ server is configured in the WAN Setup screen, as discussed in
on page 42.
DMZ Server
Before starting, you need to determine which type of service, application, or game you will
provide, and the local IP address of the computer that will provide the service. Be sure the
computer's IP address never changes.
To ensure that your server computer always has twireless routerhe same
Tip:
IP address, use the reserved IP address feature of your wireless router.
See
Using Address Reservation
use reserved IP addresses.
To configure port forwarding to a local server:
Select Port Forwarding/Port Triggering under Advanced in the main menu. The Port
1.
Forwarding/Port Triggering screen displays.
on page 39 for instructions on how to
Chapter 6: Fine-Tuning Your Network
Setting Up a Default
| 61