Setting The Capacitor Detection Method - Alcatel-Lucent OmniSwitch 6850 Series Hardware User's Manual

Configuring Power over Ethernet Parameters

Setting the Capacitor Detection Method

By default, the PowerDsine capacitor detection method is disabled on an OmniSwitch 6850 Series switch.
To enable it, use the
followed by the slot number of the OmniSwitch 6850 Series and enable.
For example, to enable the capacitor detection method on the OmniSwitch 6850 Series switch with slot
number 2, enter:
-> lanpower capacitor-detection 2 enable
To disable it, use the
tion followed by the slot number of the OmniSwitch 6850 Series and disable.
For example, to disable the capacitor detection method on the OmniSwitch 6850 Series switch with slot
number 2, enter:
-> lanpower capacitor-detection 2 disable
Note. The capacitive detection method should only be enabled to support legacy IP phones. This feature is
not compatible with IEEE specification 802.3af. Please contact your Alcatel-Lucent sales engineer or
Customer Support representative to find out which Alcatel-Lucent IP phones models need capacitive
detection enabled.
page 3-8
lanpower capacitor-detection
lanpower capacitor-detection
Installing and Managing Power over Ethernet (PoE)
command by entering lanpower capacitor-detection
command by entering lanpower capacitor-detec-
OmniSwitch 6850 Series Hardware Users Guide August 2007