Adjusting Support Bearings - Grizzly G8976 Instruction Manual

6. Now, slowly increase the tension until the
blade stops fluttering, then tighten the ten-
sion one more quarter of a turn.
7. Tighten the wheel lock knob bolt loosened in
step 3.
NOTICE
All bandsaw blades will stretch. To reduce
this stretching, remove the tension from the
blade when not in use.
NOTICE
After blade tension and tracking are set cor-
rectly, properly adjust the upper and lower
support bearings and guide-block assem-
blies into position before cutting operations.
-20-
Adjusting Support
Bearings
The support bearings are positioned behind the
blade. They support the back of the blade during
cutting operations. Proper adjustment of the sup-
port bearings ensures accurate cuts by eliminat-
ing front-to-back blade flex. There is a support
bearing both above and below the table.
To adjust the support bearings:
1. Make sure the blade is tracking properly and
that it is correctly tensioned.
2. Disconnect the machine from the power
source!
3. Loosen the hex nut shown in Figure 22.
Upper Support
Bearing Hex Nut
Figure 22. Upper blade guide assembly.
G8976 3 Wheel 12" Bandsaw