Assembly; Beginning; Table - Grizzly G3619 Instruction Manual

SECTION 4: ASSEMBLY

Beginning

The photos used in this manual are of the Model
G9966. They are used for illustrative purposes
only and any differences between the 24" and the
27" Bandsaws will be discussed in that particular
section.
To complete the assembly process, follow the
instructions in this section.
NOTICE
When the fence is to the left of the blade, it
must be positioned near the center of the
table in order to open the lower wheel
cover.
24" & 27" Resaw Bandsaws
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Keep power disconnect-
ed from machine when
performing the assembly
process. Failure to do
this may result in serious
personal injury.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.

Table

The table for this bandsaw
is very heavy. Get help
when placing it on the
trunnion.
To mount the table:
1.
Installing the table is easiest if the blade is
out of the way. Remove the blade by first
loosening the blade tension handwheel, then
by sliding it off the bandsaw wheels. Wear
heavy leather gloves to protect your hands.
2.
With the help of another person, lift the table
onto the trunnion.
3.
Place the large hex bolt with washer through
the table trunnion mount and the trunnion.
Do not tighten the bolt completely at this
time. The assembly should now look similar
to Figure 4.
Blade Tension
Handwheel
Figure 4. Table installed correctly.
-11-