Blade Guard; Table Stop - Grizzly G3619 Instruction Manual

Blade Guard

The blade guard is attached to the guide post
above the upper blade guide assembly. For prop-
er setup, the blade should be centered in the
blade guard.
To center the blade guard:
1.
Loosen the hex bolt that secures the blade
guard bracket to the guide post.
2.
Rotate the blade guard bracket in the appro-
priate direction until the blade guard is cen-
tered around the blade as illustrated in
Figure 14.
3.
Tighten the hex bolt that secures the blade
guard bracket to the guide post.
Blade
Guard
Blade centered in blade guard.
Figure 14.
-18-
Blade

Table Stop

The positive stop under the table (see Figure 15)
allows you to repeatedly square up the table after
adjusting the table tilt. To adjust the positive stop
so the table will return perpendicular (90°) to the
blade after angle cutting:
1. Make sure the bandsaw is unplugged!
Figure 15. Positive stop.
Always
power to the machine
when
ments. Failure to do this
may result in serious
personal injury.
24" & 27" Resaw Bandsaws
disconnect
making adjust-