Spirit F8500 Instruction And User's Manual page 21

PROGRAMMABLE OPERATION OF YOUR TREADMILL
Using a Heart Rate Transmitter
How to wear your wireless chest strap transmitter:
1. Attach the transmitter to the elastic strap using the locking parts.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain
comfortable.
3. Position the transmitter with the logo centered in the middle of your body facing away from
your chest (some people must position the transmitter slightly left of center). Attach the final
end of the elastic strap by inserting the round end and, using the locking parts, secure the
transmitter and strap around your chest.
4. Position the transmitter immediately below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals. However,
plain water can also be used to pre-wet the electrodes (2 black square areas on the
reverse side of the belt and either side of transmitter). It's also recommended that you wear
the transmitter strap a few minutes before your work out. Some users, because of body
chemistry, have a more difficult time in achieving a strong, steady signal at the beginning.
After "warming up", this problem lessens. As noted, wearing clothing over the transmitter/
strap doesn't affect performance.
6. Your workout must be within range - distance between transmitter/receiver – to achieve
a strong steady signal. The length of range may vary somewhat but generally stay close
enough to the console to maintain good, strong, reliable readings. Wearing the transmitter
immediately against bare skin assures you of proper operation. If you wish, you may wear the
transmitter over a shirt. To do so, moisten the areas of the shirt that the electrodes will rest
upon.
Note: The transmitter is automatically activated when it detects activity from the user's heart.
Additionally, it automatically deactivates when it does not receive any activity. Although the
transmitter is water resistant, moisture can have the effect of creating false signals, so you
should take precautions to completely dry the transmitter after use to prolong battery life
(estimated transmitter battery life is 2500 hours). The replacement battery is Panasonic
CR2032.
Erratic Operation:
Caution! Do not use this treadmill for Heart Rate Control unless a steady, solid Actual Heart
Rate value is being displayed. High, wild, random numbers being displayed indicate a
problem.
Areas to look at for interference:
(1) Treadmill not properly grounded - A must!
(2) Microwave ovens, TV's, small appliances, etc.
(3) Fluorescent lights.
(4) Some household security systems.
(5) Perimeter fence for a pet.
(6) Loose bolts on the treadmill console or upright tubes.
(7) The antenna that picks up your heart rate is very sensitive. If there is an outside noise
source, like a radio/cell tower or high tension electric power lines, turning the whole machine 90
degrees may de-tune the interference.
WARNING!
DO NOT USE THE HEART RATE CONTROL PROGRAM IF YOUR HEART RATE IS NOT
REGISTERING PROPERLY ON THE TREADMILL'S DISPLAY!
10156
page-19