Spirit F8500 Instruction And User's Manual page 24

PROGRAMMABLE OPERATION OF YOUR TREADMILL
Calibration procedure:
1. Remove the safety key
2. Press and hold down the Start and Fast (speed up) buttons with one hand and replace the
safety key with the other. Continue to hold the Start and Fast key until the window displays
"Factory settings", then press the enter key.
3. You will now be able to set the display to show Metric or English settings. To do this press
the up or down key to show which you want, then press enter.
4. Make sure the wheel size diameter is 2.810 then press enter
5. Adjust the minimum speed (if needed) to
6. Adjust the maximum speed (if needed) to
7. Adjust the maximum elevation (if needed) to 15 and then press enter
8. Press start to begin calibration. The process is automatic; the speed will start up without
warning so do not stand on the belt.
Adjusting the speed sensor:
If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it in place (you do not
need to remove them completely).
2. The speed sensor is located on the left side of the frame, right next to the front roller pulley
(the pulley will have a belt around it that also goes to the motor). The speed sensor is small
and black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley without touching it. You will see a
magnet on the face of the pulley; make sure the sensor is aligned with the magnet. There is
a screw that holds the sensor in place that needs to be loosened to adjust the sensor. Re-
tighten the screw when finished.
page-22
1.0 km (0.5mile) and then press enter
18.0 km (12 mile) and then press enter
10156