Table of Contents
Advertisement
CLEANING INSTRUCTIONS
CAUTION:
ELECTRIC SHOCK
HAZARD
Disconnect appliance from
electric power
before cleaning.
CAUTION:
BURN HAZARD
Allow appliance to cool
completely before cleaning.
Do not attempt to clean the
oven until it has cooled to
150ºF or less. It can burn
you. Hand protection is
required.
CAUTION:
CUT HAZARD
FAN BLADES ARE SHARP.
Use due care when cleaning
and/or wiping.
IMPORTANT: DO NOT spill
or pour water into controls,
control panel or wiring.
Damage to internal
components from water
damage is not covered by
warranty.
Assembling Fan Baffle
& Rack Support
PREPARATION
Allow oven to cool to 65ºC or less
FREQUENCY
Daily
TOOLS
Fiber Brush,
Mild Detergent, McD Sanitizer,
Clean Towel
CLEANING
1. Turn POWER SWITCH to FAN. With the door held open, allow the
oven to cool. When the oven interior has cooled to 65ºC or less,
turn the POWER SWITCH to OFF.
2. Remove racks and rack supports. Remove fan baffle.
3. Brush the fan wheel and wipe it with a moist cloth. Sponge out all
loose particles.
4. Wipe down the entire interior using a clean cloth moistened with
hot water and a mild detergent. Rinse by wiping with a clean towel
moistened with sanitizer.
IMPORTANT: Always wipe or rub in the direction of the polish
lines or grain of the metal.
5. Clean oven racks and rack supports in a sink or dishwasher.
6. Reinstall the fan baffle, paying particular attention that the lip on
the right side of the fan baffle is fully seated in the slot in the edge
of the oven cavity. Reinstall rack supports and racks.
IMPORTANT: Take care to avoid damage to fan blades
when reinstalling fan baffle.
7. Turn power switch to FAN . Verify that fan runs smoothly and does
not contact fan baffle. Turn power switch to OFF. Reposition fan
baffle if necessary.
8. Wipe down the prep top and exterior of the oven using a clean
cloth moistened with hot water and a mild detergent. Rinse by
wiping with a clean towel moistened with sanitizer.
IMPORTANT: Always wipe or rub in the direction of the polish
lines or grain of the metal.
9. Replace oven rack supports. Leave the door open overnight.
PROCEDURE IS COMPLETE
10
Advertisement
Table of Contents
