Table of Contents
Advertisement
CAUTION: Electrical Shock Hazard
Removal of any cabinet panel will result in exposed electrical circuits.
Any procedure requiring the removal of any cabinet panel must be performed
by a qualified technician only.
CAUTION: Electrical Shock Hazard
Fuse replacement may expose dangerous voltages.
Fuse replacement must be performed by a qualified technician.
SYMPTOM
No power to appliance
Oven will not heat
Blower fan will not run
Door pops open during
cook cycle
POSSIBLE CAUSE
Circuit breaker off or tripped
Fuse blown or loose
Power switch turned to OFF or FAN
Temperature control not set
Oven door not closed
Hi-limit control tripped on excessive
oven temperature
Damaged controller
Fan switch OFF
Damage to internal components
Latch out of adjustment
13
TROUBLESHOOTING SUGGESTIONS
SUGGESTED REMEDY
Reset circuit breaker
Check power fuses. If blown,
correct problem and replace
fuses
Turn power switch ON
Set to desired temperature
Be sure door is closed and
latched
Allow oven to cool
Hi-limit will reset
Contact Authorized Wells
Service Agency for repairs
Turn fan switch to HIGH or
LOW
Contact Authorized Wells
Service Agency for repairs
Adjust latch
NOTE: There are no user
serviceable components in the
appliance. In all cases of
damage or component
malfunction, contact your
Authorized Wells Service
Agency for repairs.
Advertisement
Table of Contents
