Grizzly G0652 Owner's Manual page 58

clamping pressure and parallelism
the fence clamping mechanism adjusts the
clamping pressure the right amount to hold your
fence securely and position the fence parallel to
the miter slot.
remove the fence and, using a 4mm hex wrench,
adjust the set screws shown in figure 82 equally
on the rear side of the front bracket.
Fence
Bracket
figure 82. set screw adjustments.
place the fence alongside the miter slot (figure
83), and check the fence to miter slot parallelism.
also, check the fence clamping strength by push-
ing and pulling the fence with moderate pressure
by hand.
-56-
set
screws
figure 83. example of fence aligned parallel to
miter slot.
trial-and-error will be needed to adjust the set
screws so the fence is parallel to the miter slot
and the clamping pressure is sufficient.
Optional: if you are cutting wet or green stock,
offsetting the rear of the fence
by using the set screws in figure 82 can help pre-
vent the workpiece from binding and burning.
g0651/g0652 10" extreme series table saws
/ " from the blade
1
64