Grizzly G0652 Owner's Manual page 24

6.
Fasten the 79" rear rail to the extension table
with three m8-1.25 x 25 cap screws, three
lock washers, six flat washers, and three hex
nuts, as shown in figure 15. Finger tighten
for now.
x 3
figure 15. rear rail/table fastener locations.
7.
align the table and extension table with a
straightedge (figure 16), then tighten the
fasteners in figure 14 with a 5mm hex
wrench and 13mm wrench.
figure 16. aligning main extension table.
8.
repeat the aligning procedure and tighten
the fasteners in figure 15 with a 6mm hex
wrench and 13mm wrench.
9. tighten the cap screws shown in figure 13.
10. install each foot with a
into the bottom of a support leg, as shown in
figure 17.
-22-
⁄ -16 hex nut onto
3
8
support leg
hex nut
figure 17. Foot installed on support leg.
11. Fasten each support leg to the main exten-
sion table with four m6-1 x 12 phillips head
screws and flat washers, as shown in figure
18.
x 4
figure 18. support leg fastened to main
extension table.
12. rotate both feet until they touch the ground,
and tighten the hex nuts against the support
legs to secure the feet.
g0651/g0652 10" extreme series table saws
Foot