Grizzly G0652 Owner's Manual page 34

combination blade features:
• adequate for cutting both with and across the
grain.
• 40-50 teeth.
• alternate top bevel and flat, or alternate top
bevel and raker tooth profile.
• teeth are arranged in groups of five.
• gullets are small and shallow within the
groups of five teeth, similar to a cross-cut
blade; then large and deep between each
group of five, like a ripping blade.
figure 38. Combination blade.
Laminate blade features:
• Best for cutting plywood or veneer.
• 40-80 teeth.
• triple chip tooth profile.
• very shallow gullet.
figure 39. laminate blade.
-32-
Dado Blades:
there are two types of dado blades: stacked and
wobble.
• Stacked Dado Blade: these dedicated dado
cutting blade sets consist of up to 8 indi-
vidual blades. multiple cutters are "stacked"
between two outside blades. the width of
the dado is determined by the combination of
cutters that are "stacked" together. the dado
is cut in a single pass leaving a smooth and
square channel in the face of the workpiece.
stacked dado blades are the most expen-
sive option, but are worth considering if your
projects require a lot of visible dado cuts. a
stacked dado blade is shown in figure 40.
figure 40. stacked dado blade.
Wobble Dado Blade: also a dedicated dado
•
blade, a wobble blade usually consists of a
single blade that is tilted on the arbor shaft
while it is spinning. the channel is cut in the
face of the workpiece as the blade pass-
es through its pre-adjusted width of travel.
Wobble blades are an inexpensive option
when visibly pleasing channels are not a con-
cern.
g0651/g0652 10" extreme series table saws