Grizzly G0652 Owner's Manual page 52

Installing New Belt
1.
turn the flat belt sideways and slip it over
the motor pulley, so it engages one or two
grooves (figure 67).
motor pulley
figure 67. installing flat belt (table removed for
clarity.)
2. push the belt inward and roll it onto the top
pulley. Continue pushing the belt and rotating
it up and down (figure 68) until it is centered
on both pulleys.
Flat Belt
figure 68. Flat belt installed (table removed for
clarity.)
3. lower the motor all the way down.
4. loosen the motor mounting hex nuts two
turns, then place the wood block on top of the
motor.
-50-
Flat Belt
5.
raise the motor to tension the belt, ensuring
that the wood block is between the motor and
cabinet, as shown in figure 69.
Note: Be careful not to damage the motor,
and do not force it up further when it becomes
difficult to move the handwheel.
Wood
Block
figure 69. using wood block to tension belt.
6. Check belt deflection, as shown in figure 70.
adjust deflection by raising or lowering the
motor until you can deflect the belt no more
than ⁄ ".
1
8
figure 70. Checking belt deflection.
7. tighten the motor mounting hex nuts, lower
the motor, and remove the wood block.
8.
Close the motor cover.
g0651/g0652 10" extreme series table saws