Grizzly G0652 Owner's Manual page 25

13. Fasten the shelf end plate to the legs with
four m6-1 x 12 phillips head screws and flat
washers, as shown in figure 19.
x 4
figure 19. installing shelf end plate on extension
table legs.
14. place the shelf brackets between the cabinet
and support legs, and fasten with two m6-1
x 12 phillip head screws, two m6-1 x 12 hex
bolts, four flat washers and two hex nuts, as
shown in figure 20.
Note: The flange on the shelf bracket must
point up to ensure proper installation.
shelf Bracket
x 2
figure 20. shelf brackets installed.
15. place the lower shelf on the brackets.
16. turn the outfeed table upside down and
place it on a level surface.
g0651/g0652 10" extreme series table saws
Flange
x 2
17. repeat Steps 10-13 to install the feet, sup-
port legs, and shelf end plate on the outfeed
table.
18. place the outfeed extension table assembly
upright with the feet on the ground, align the
slots in the extension table bracket with the
rear rail mounting holes, then fasten the table
to the rail with two m8-1.25 x 20 hex bolts, flat
washers, and hex nuts, as shown in figure
21.
figure 21. outfeed table fastened to rear rail.
19. secure the lower shelf brackets to the sup-
port legs and cabinet, using the same fasten-
ers as in Step 14.
20. install the lower shelf on the brackets.
21. place the 91 / " fence tube over the 91
1
2
front rail and secure with nine m8-1.25 x 12
hex bolts with washers, as shown in figure
22.
handwheel
handles
figure 22. Fence tube mounted to front fence
rail.
22. install the handwheel handles, as shown in
figure 22.
Bracket
x 2
1
x 9
-23-
/ "
2