Table of Contents
Advertisement
U
INT3000
SING THE
Handset Controls
TALK Key
When you pick up the Handset and press
Then, you will see one of the following:
•
After the connection has been made between the Handset and Base Unit "TALK"
will appear on the display. Then the screen will go into standby mode and the
phone is ready to use.
•
If there is no connection to the Base Unit, you hear an error tone and NO SER-
VICE appears on the display.
•
If the channel is busy, you hear an error tone and the display shows SYSTEM
BUSY.
You must have a connection between the Handset and the Base Unit to perform any
operation. If the Handset does not respond when you attempt to place a call or enter a
feature code, press
CHANNEL Key
If you have more than one cordless telephone in your office, they must operate on dif-
ferent channels. Press
cation.
R/VOL Key
•
During a Call: Press
volume level.
•
Standby Mode: Press
A (High or Low), Ring Type B (High or Low), Ring Type C (High or Low), or
Ring Off (vibrate mode).
SPCL Key
This key allows you to use feature codes while on a call. Instructions are provided in
this guide for using the SPCL key.
There is a system-wide option called "SPCL Key Required For Feature Code Entry."
If your customer service representative, trainer, or system administrator tells you that
it is enabled in your telephone system, you must always press the SPCL key before
dialing a feature code.
4
to acquire a link.
talk
to select a channel that provides the clearest communi-
channel
on the side of the Handset to select a high or low
r / vol
on the side of the Handset to select from Ring Type
r / vol
, you will see ACQUIRING LINK.
talk
INT3000 Cordless Telephone User Guide
Advertisement
Table of Contents
