Maintenance - Ryobi EAG1518RG Owner's Operating Manual

POLISHING
See Figure 7.
The polishing feature is designed to bring shine to the
painted surfaces of timber and metal. Work the tool in the
lowest speed setting; if used with higher speed, the paint
or fi nish can burn.
SANDING
See Figure 8.
Choose sanding paper carefully for each application for
best operation and fi nish. To have the best sanding result,
it is recommended to work with lower speed. Use the
sanding feature for sanding off old paint from timber and
metal surfaces. It can also be used for smoothing timber
surface.
Recommend to use sanding pad with minimum no-load
speed 7200/min. The maximum no-load speed of unit
is 6500/min.
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.

MAINTENANCE

After use, check the tool to make sure that it is in good
condition.
It is recommended that you take the tool to a Ryobi
authorised service center for thorough cleaning and
lubrication at least once a year.
Do not make any adjustments while the motor is in
motion.
Always disconnect the power cord from the socket
before changing removable or expendable parts
(grinding disc, cutting disc etc), before lubricating or
working on the unit.
If the supply cord is damaged, it shall be replaced by
the manufacturer or its service agent or similar qualifi ed
person in order to avoid a hazard.
To ensure safety and reliability, all repairs should be
performed by an authorised service center or other
qualifi ed service organisation.
WARNING
WARNING
WARNING
6