Maintenance - Ryobi ECS-1214N User Manual

GB
F D
OPERATION
Follow these steps to empty the dust bag:
Unplug the sander.
■
WARNING
Failure to unplug the tool could result in
accidental starting causing possible serious
injury.
Remove the dust bag from the sander.
■
Shake out the dust.
■
Reattach the dust bag to the sander.
■
For a more thorough cleaning of the dust bag, remove
dust bag from frame, as shown in figure 7, and shake out
dust. Replace dust bag over frame then install dust bag
assembly on sander.
CHANGING THE SANDING SHEETS (Fig. 8)
The sander is packed with sanding sheets and pads
designed for a variety of uses. To change sheets,
simply pull the used sheet off the base and attach the
desired sheet by pressing the sheet or pad onto the
base of the sander.
PAPER PUNCH (Fig. 9)
A paper punch template has been supplied with your
sander for aligning and punching holes in sandpaper.
The punched holes must align with the holes in the
sander cushion.
Install sandpaper on your sander.
■
Align sander cushion over the paper punch.
■
Push down on the sander.
■
ROTATING THE SANDING SHEETS (Fig. 10)
The majority of wear in a precision sanding application
occurs at the tip of the sanding sheet. The unique
Tri-Flex design of the sanding sheets and scrubbing pads
allows you to detach and rotate the top two thirds of each
and extend the life of the pad or sheet.
To rotate the top of the pad or sheet, simply remove the
top two thirds along the perforation. Rotate the pad or
sheet so that a clean corner is located at the tip of the
base. Press the pad or sheet firmly onto the pad.
E I P NL S DK N FIN GR
English
LIVE TOOL INDICATOR
This tool features a live tool indicator (6) which
illuminates as soon as the tool is connected to the supply.
This warns the user that the tool is connected and will
operate when the switch is pressed.

MAINTENANCE

GENERAL
Avoid using solvents when cleaning plastic par ts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently,
we do not recommended using this tool for extended
work on these types of materials. However, if you do work
with any of these materials, it is extremely important to
clean the tool using compressed air.
12
RO
H CZ RUS
WARNING
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance,
or when the tool is not in use. Disconnecting the
tool will prevent accidental starting that could
cause serious injury.
WARNING
When ser vicing use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING
Do not at any time let brake fluids, gasoline,
petroleumbased products, penetrating oils, etc.,
come in contact with plastic parts. They contain
chemicals that can damage, weaken, or
destroy plastic.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
HR
PL SLO TR