Mounting Bandsaw; Mounting Trunnion Base - Grizzly G0555 Instruction Manual

Mounting Bandsaw

Get assistance from an-
other person when lifting
the bandsaw onto the
stand or moderate per-
sonal injury may occur.
To mount the bandsaw to the stand:
1. Get an assistant to help you lift the bandsaw
and place it on top of the stand.
2. Line up the mounting holes on the bandsaw
base with those on the stand top, so that the
front of the bandsaw is closer to the stand
edge than the back of the bandsaw.
3. Secure the bandsaw to the stand with the (4)
M8-1.25 x 35 hex bolts, (8) 8mm flat wash-
ers, (4) 8mm lock washers, and (4) M8-1.25
hex nuts from the hardware bag. The band-
saw should now be mounted to the stand as
shown in Figure 13.
Figure 13. Bandsaw mounted to stand.
G0555 14" Ultimate Bandsaw
Mounting
Trunnion Base
To mount the trunnion base:
1. Place the trunnion base on the bandsaw as
shown in Figure 14.
2. Fasten the trunnion base to the bandsaw
with the (2) M8-1.25 x 30 hex bolts and (2)
8mm lock washers from the hardware bag.
Figure 14. Installing trunnion base.
Trunnion
Base
-15-