Bench Mounting; Assembly - Grizzly G0885 Owner's Manual

Bench Mounting

Number of Mounting Holes ............................ 3
Diameter of Mounting Hardware Needed ..
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 7. "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 8. "Direct Mount" setup.
Model G0885 (Mfd. Since 04/19)
⁄ "
1
4
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
The G0885 work stop and base feet are the only
components requiring assembly.
To assemble machine:
1.
Thread work stop rod with hex nut into vise
base (see Figure 9).
2.
Slide work stop onto work stop rod (see
Figure 9).
3.
Insert hex bolt into work stop and thread work
stop lock handle onto hex bolt (see Figure 9).
Work Stop
Work Stop
Lock
Handle
Hex Bolt
Figure 9. Work stop installed.
Work Stop Rod
with Hex Nut
-13-