Bench Mounting; Assembly - Grizzly T31634 Owner's Manual

Bench Mounting

Number of Mounting Holes ............................ 4
Dia. of Mounting Hardware Needed ..........
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 11. "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 12. "Direct Mount" setup.
-18-
⁄ "
5
16
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer

Assembly

Assembly of Model T31634/T31635 consists
of adjusting the miter and bevel angles to 0˚,
unlocking the cutting head, and attaching a dust
collection system.
Adjusting Miter to 0˚
1.
Lift miter lock handle to unlock table position
(see Figure 13).
Figure 13. Miter lock handle in unlocked
position.
2. Press and hold miter release button (see
Figure 13) and use miter lock handle to push
cutting arm until miter angle indicator displays
0 degrees (see Figure 14).
Miter Angle
Scale
Indicator
Figure 14. Miter angle adjusted to 0˚.
3. Use miter lock handle to lock table position.
Model T31634/T31635 (Mfd. Since 8/19)
Miter Release
Button
Miter Lock
Handle
Cutting Arm