Table of Contents
Advertisement
6.
place the guide post guard on top of the
guide post assembly so you can access the
guide post bracket.
7.
loosen the four screws shown in figure 67
enough to fit metal shims between the frame
and the guide post bracket (see figure 69).
—if the guide post to blade distance is greater
at the bottom than at the top, place a shim
between the bottom of the bracket and the
frame (shim "a"). this will tilt the bottom of
the guide post toward the blade.
—if the guide post to blade distance is less
at the bottom than at the top, place a shim
between the top of the bracket and the
frame (shim "B"). this will tilt the bottom of
the guide post away from the blade.
figure 69. location for placing shims.
-52-
8.
tighten the four screws shown in figure 67,
then repeat Steps 4–5.
—if the measurements are equal, go to Step
9.
—if the measurements are not equal, con-
tinue adding shims as needed until guide
post rack to blade distance is the same at
the top and bottom.
9.
reinstall the guide post guard with the screws
removed in Step 3.
Model g0513/g0514 (Mfg. 8/02+)
Advertisement
Table of Contents
