Guide Post Handwheel; Table - Grizzly G0513P Owner's Manual

Guide post
Handwheel
To install the guide post handwheel:
1. insert the guide post handwheel onto the
shaft, and secure it with the cap screw on
the flat side of the shaft, as shown in figure
15.
figure 15. guide post handwheel installed.

Table

the table is heavy and requires two people to lift
it onto the trunnions. remove the saw blade to
make table installation easier.
To install the table:
1. loosen blade tension by rotating the quick
release tension lever clockwise as shown in
figure 16.
loosen
tighten
figure 16. Quick release tension lever.
-18-
2.
adjust the upper and lower blade guides
away from the blade. refer to Blade Guides
on page 24 for more details.
All saw blades are dan-
gerous and may cause
personal injury. To reduce
the risk of being injured,
wear leather gloves when
handling saw blades.
3.
open the upper and lower wheel covers, and
slide the blade off of both wheels.
personal injury may occur
if the table is lifted without
assistance. Get help when
installing the table.
4.
With the help of another person, lift the table
onto the trunnions.
5.
secure the table to the trunnions as shown
in figure 17 with the (4) M8-1.25 x 16 hex
bolts, 8mm lock washers, and 8mm flat wash-
ers.
trunnions
figure 17. Mounting the table.
Model g0513/g0514 (Mfg. 8/02+)