Cleaning The Front Panel; Removing The Front Panel; Cleaning The Air Filter; Installing The Front Panel - Trane CWCS Operation Manual

CARE AND MAINTENANCE

Cleaning the front panel

Removing the front panel

1. Pull the front panel PULL buttons (two places) downward and
open it.
2. Remove the front panel by opening it 100¢Xto 120¢X, take the
two axles out, then the front panel can be taken away.
100 ¢X ~120
Cleaning the front panel
Use a vacuum cleaner to remove dust accumulations, then wipe
the grille with a clean cloth dipped in warm water; wipe with a
clean dry cloth to remove any water.

Installing the front panel

1. Tilt the front panel 100¢Xto 120¢X, then insert the two axles.
24
Take the filter out in
the direction of the
¢X
arrow.
Front panel hooks
Axles
2. Hook the hooks to the front panel hooks shaft.
3. Push the front panel PULL buttons (two places) until you
hear a "click".
Front panel hooks

Cleaning the Air Filter

If dirt is allowed to collect in the air fiter, the airflow will be
reduced, leading to reduced performance, and increased
operation noise. Be sure to clean the filters at the beginning
of the operating season, and about every two weeks during
periods of frequent operation.
Removing and installing the Air Filter
1. Move the front panel 100¢X to 120¢X.
2. Take the filter out.
3. To install the air filter, follow the opposite procedure of
"Removing".
Cleaning the electrostatic precipitation grill
1. Switch off the power supply.
2. Open the front panel.
3. Take out the electrostatic precipitation grill (be carefull to
not be stung by the needles)
4. Wash it with water or add little detergente.(after washing, it
must be dried defore reinstalling, in order to avoid any
electric leakage).
Take the electrostatic
precipitation grill out this
direction.
CAUTION!
Do not put the fingers or other things into the front panel,
¡·
in order to avoid any electric shock.
The power supply must be switched off before cleaning
¡·
the electrostatic precipitation grill.