Seat Cushion/Seat Cover Assembly; Seat Assembly; Rear Support Frame/Rear Decorative Cover Assembly - Smooth Fitness Sit N Cycle Owner's Manual

"A
I
SSEMBLY NSTRUCTIONS"
S –
TEP 2

Seat Assembly

S –
TEP 3 Rear Support Frame & Rear Decorative Cover Assembly
S –
TEP 1 Seat Cushion & Seat Cover Assembly
a. For ease of assembly, turn the Lower Seat Cover Assembly (3) and the Seat
Cushion (16) upside down.
b. Place the Lower Seat Cover Assembly (3) onto the Seat Cushion (16) and secure
with two Bolts (M8xp1.25x30mm)(40) as the drawing depicts on the left.
a. Remove the Main Frame Assembly (1) along with the die-cut
Styrofoam (A) from the carton.
b. Lay the unit with the Styrofoam attached on the floor. See diagram the
on the left.
NOTE: Failure to use the Styrofoam as support for the main frame
assembly may cause damage to the Sit N Cycle.
c. Slide the Seat (3) into the Main Frame (1) as the drawing depicts on the
right.
Step a, b, c.
d. Then secure the Seat (3) with 2 x Lock Washers (M8)(29), 2 x Bolts
(M8xp1.25x16mm)(39) and 1 Bolt, Socket Head
(M8xp1.25x50mm)(41) as the drawing depicts on the left. NOTE: The
larger bolt is used in the middle bolt hole
Step d.
a. Attach the Rear Support Frame (2) to the Main Frame Assembly (1)
and secure with the two Hex Head Bolts, (M8xp1.25x50mm)(49), the
two Lock Washers (M8)(29) and two Washers (8x38x2.0t)(30).
b. Attach the Rear Decorative Cover (13) to the Main Frame Assembly
(1) and secure it with the four Screws (M4x12mm)(33).
a. Stand the Main Frame Assembly (1) upright, then remove the
die-cut Styrofoam (A).
**Make sure the above parts are fully tightened before moving on to the
next page**
6