Table of Contents
Advertisement
Features of your vehicle
4. Slowly allow the shoulder portion of
the safety belt to retract and listen for
an audible "clicking" or "ratcheting"
sound. This indicates that the retractor
is in the "Auto Lock" mode. If no distinct
sound is heard, repeat steps 3 and 4.
3
82
MMSA3029
5. Remove as much slack from the belt
as possible by pushing down on the
child restraint system while feeding the
shoulder belt back into the retractor.
6. Push and pull on the child restraint
system to confirm that the safety belt is
holding it firmly in place. If it is not,
release the safety belt and repeat
steps 2 through 6.
7. Double check that the retractor is in
the "Auto Lock" mode by attempting to
pull more of the safety belt out of the
retractor. If you cannot, the retractor is
in the "Auto Lock" mode.
To remove the child restraint, press the
release button on the buckle and then
pull the lap/shoulder belt out of the
restraint and allow the safety belt to
retract fully.
WARNING
The lap/shoulder belt automatically
returns to the "emergency lock
mode" whenever the belt is allowed
to retract fully. Therefore, the pre-
ceding seven steps must be fol-
lowed each time a child restraint is
installed.
If the safety belt is not placed in the
"Auto lock" mode, severe injury or
MMSA3030
death could occur to the child
and/or other occupants in the vehi-
cle in a collision, since the child
restraint will not be effectively held
in place.
When the safety belt is allowed to
retract to its fully stowed position, the
retractor will automatically switch
from the "Auto Lock" mode to the
emergency lock mode for normal
adult usage.
- Auto lock
mode
Advertisement
Table of Contents
