Table of Contents
Advertisement
Flashing
1. When programming the buttons for the
first time, press and hold the left and
,
center buttons (
) simultane-
ously until the indicator light begins to
flash after approximately 20 seconds.
(This procedure erases the factory-set
default codes. Do Not perform this step
to program additional hand-held trans-
mitters.)
✽ ✽ NOTICE
For non rolling code garage door open-
ers, follow steps 2 - 3.
For rolling code garage door openers,
follow steps 2 - 6.
For Canadian Programming, please fol-
low the Canadian Programming section.
For help with determining whether your
garage is non-rolling code or rolling
code, please refer to the garage door
openers owner's manual or contact
®
HomeLink
customer service at 1-800-
355-3515.
OVQ036306N
Features of your vehicle
Flashing
Transmitter
2. Press and hold the button on the
®
HomeLink
system you wish to train
and the button on the transmitter while
the transmitter is approximately 1 to 3
inches away from the mirror. Do not
release the buttons until step 3 has
been completed.
®
3. The HomeLink
indicator light will
flash, first slowly and then rapidly.
When the indicator light flashes rapidly,
both buttons may be released. (The
rapid flashing light indicates successful
programming of the new frequency sig-
nal.)
✽ ✽ NOTICE
Some gate operators and garage door
openers may require you to replace step
#3 with the "cycling" procedure noted in
the "Canadian Programming" section of
this document.
OVQ036307N
3 179
Advertisement
Table of Contents
