Kia Sedona 2014 Owner's Manual page 194

Reprogramming a single
®
HomeLink button
To program a device to HomeLink
®
a HomeLink button previously trained,
follow these steps:
1. Press and hold the
®
HomeLink button. Do NOT release
until step 4 has been completed.
2. When the indicator light begins to flash
slowly (after 10 seconds), position the
hand-held transmitter 1 to 3 inches
®
away from the HomeLink surface.
3. Press and hold the hand-held trans-
mitter button (or press and "cycle" - as
described in "Canadian Programming"
above).
®
4. The HomeLink indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to flash
rapidly, release both buttons.
The previous device has now been
erased and the new device can be acti-
vated by pushing the HomeLink
that has just been programmed. This pro-
cedure will not affect any other pro-
®
grammed HomeLink buttons.
Gate operator programming &
canadian programming
®
using During programming, your hand-held
transmitter may automatically stop trans-
mitting. Continue to press and hold the
®
HomeLink button (note steps 2 through
desired
4 in the "Programming" portion of this
text) while you press and re-press
("cycle") your handheld transmitter every
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
CAUTION
If programming a garage door
opener or gate, it is advised to
unplug the device during the
"cycling" process to prevent possi-
ble motor burn-up.
®
button
Features of your vehicle
Accessories
If you would like additional information on
®
the HomeLink Wireless Control System,
®
HomeLink compatible products, or to
purchase other accessories such as the
®
HomeLink Lighting Package, please
®
contact HomeLink at 1-800-355-3515
or on the internet at www.homelink.com.
This device complies with Part 15 of
the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
WARNING
®
The HomeLink transmitter has
been tested and complies with FCC
and DOC/MDC rules. Changes or
modifications not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the
equipment.
IC: 4112104541A Gentex
MODEL/FCC ID: NZLSTDHL3
3 185