Changing The Cutting Unit's Belts - Husqvarna Rider 20 ProFlex Operator's Manual

Replacing the cutting unit's belts
Belt replacement on the BioClip unit
Two transmission belts that synchronise the
rotation of the blades power a BioClip unit. The
belts are located under a hood on the cutting unit.
1. Loosen the parallelism arm's front pin/bolt and
fold the arm backwards.
2. Loosen the two bolts holding the protective
hood and then lift off the hood.
3. Loosen the nuts on the eccentric plate and turn
this away.
Loosen the four nuts (see diagram) holding the
outer blade bearing enough so that the bearing
can be moved.
Slide the blade bearing in towards the centre
bearing and pry off the upper belt.
Repeat the procedure for the lower belt.
!
WARNING!
Protect your hands by wearing
gloves when working with the
blades.
MAINTENANCE
35
English –