4. Slide in the unit so that the inner pins (B)
bottom in the attachment frame's groove.
5. Fit the height setting arm's rear bracket when
fitting the attachment. Off-load the arm by
pulling the front of the frame upwards.
6. Remove the belt adjuster's spring and fit the
belt on the front belt pulley.
7. Hook on the belt adjuster's spring again.
Note!
Check that the belt is fitted around the
tension roller.
Belt diagram
1. Drive belt
2. Drive pulley
3. Tension roller
4. Spring
MAINTENANCE
B
1
3
2
4
27
English –