Husqvarna Rider 20 ProFlex Operator's Manual page 34

9. Loosen the height setting arm by moving the
rear section upwards. When dismantling the
cutting unit, off-load the arm by pulling the
frame's front section upwards.
10. Pull the handle and unit simultaneously. Release
the handle when the unit has come out a little.
11. Pull out the unit so that it engages in the outer
hooks.
12. Lower the unit using the lever on the right-hand
side of the driver.
13. Pull the handle so that the hook guard locks.
Check that the catch (A) is in its loaded posi-
tion.
14. Lift the unit off of the Rider.
32
– English
MAINTENANCE