Table of Contents
Advertisement
lap time. Then the upper row will momentary
change to read, "Split Time," and the middle
line will show the total exercise time elapsed.
The lower line will show the average (avg)
heart rate of the lap.
Each time this process is repeated, the lap
counter in the lower right will advance by one.
The Heart Touch Function
Besides the information that can be accessed and altered by
pressing the buttons on the wrist receiver, additional information
can also be accessed by bringing the wrist receiver up to the
transmitter on your chest.
Though no information will be lost, the
display will show the time of day and the
code on which the HRM is receiving.
After three seconds the display will change to
show the target zone limits you programmed,
and after another three seconds, the display
will switch back to the normal heart rate
measure screen.
The Exercise Pause Mode: Pausing the Recording
6. If you need to momentarily interrupt the recording, press the
blue button one time. Notice that the timers are frozen but
the lower line still reflects fluctuations in heart rate. This is
called the Exercise Pause mode.
Note: From the exercise pause mode, you have three options.
First, you can resume the recording by pushing the red button.
Second, you can start the recovery calculation (see step 7). Or
thirdly, you can stop the recording altogether (see step 8).
22
E600 USA C manual.pm6
22-23
Activating the Recovery Calculation
The recovery calculation can only be activated during
the Exercise Pause mode.
7. To begin the recovery calculation, press
and hold the red button until you hear a
long beep and the upper line of the
display reads, "RecoTime". Notice that the
middle line will show a timer counting
down to zero. You can program the
amount of time in the Options mode.
When this time is up, the lower line will
momentarily show how many beats the
student recovered, then it will switch back
to his or her current heart rate. If there is
not time to record the number of heart
beats dropped, this information is stored
and can be accessed in the File mode.
Restarting or Stopping the Recording
8. You can restart the recording with a quick push of the red
button, or you can end the recording entirely by pressing the
blue button. This will take you to the Time of Day.
19.11.2002, 15:27
23
Hide quick links:
Advertisement
Table of Contents
